Bucket Dolly

Bring your Buckets With You

These bucket dollies are solving a problem we car detailers didn’t realize we had. No more cleaning the rear of your car and then having to run around to dunk your

Wash Mitt

 in your rinse/wash bucket. You’d simply install the

bucket dolly casters

 to the bottom of them and push them to your desired location. 

The quality of these bucket dollies is top-notch. They’re made in the USA. I’m using mine up to three times a week and they are built to take a beating. Some people will say that you must be crazy to spend $30 for a bucket dolly but I say if I’m going to be washing my car(s) regularly, I’m willing to make the investment while at the same time sparing my back. 

Each one will come with (3) three thumbscrews to hold your dolly in place. They’re pre-threaded so installing them will be easy to do. Do not cross-thread them as I did at first. Once in, you’ll never have to take them out. You’ll want to be careful not to torque them down too much. If you do, you’ll damage your bucket over time. 

Another thing to note is that they come with a flat bottom – there are no holes for drainage. The reason being, these are industry-wide products (janitorial services, etc.) and are not just used for car detailing. These other industries need the water to stay in the bucket. What I’ve done is drilled holes in my buckets so that water can drain out. 

If you’re planning to incorporate this into my

bucket package

, do know that it’s going to cost you but the two combine is freaking awesome!

To get the best use out of these, you’ll want to add the

Bucket Dolly Casters

.

Directions

• Turn thumb screws clockwise through the pre-threaded holes on the side
• If you’re adding casters, turn the dolly upside down and push them in the holes on the bottom – no tools needed

Specifications

Bucket Dolly

• Easy to assemble
• Super stout and durable
• Will fit most 3.5-6 gallon buckets
• Allows for smooth bucket maneuvering